|
Applications |
Installation | Specification
| Colours
|
|
There are two ways
in which your rubber tile surfacing can be installed. Where a good level
sub-base is already in place, tiles can be SURFACE MOUNTED. Using
ramped tiles on the edges and corners to avoid a trip hazard and to ease
accessibility to wheel chairs. Alternatively the tiles can be FLUSH
MOUNTED to meet the level of the surrounding area. |
 |
 |
- Allow for finished levels to the same
as existing ground levels where possible.
- Overall area of groundwork to be flat
and level.
- Where the area of groundwork must be
installed on an incline, the slope must not exceed 1:10.
- To comply with the European Standard,
the internal measurements of the surfacing must extend to a minimum
of 1.50m beyond any extremity of the playground equipment.
- Excavation to a minimum of 150mm plus
the proposed overall depth of safety tiles.
- PCC [Pre-cast concrete] or suitable
edging for your requirements, edging 900mm x 150mm (post formed)
to be installed in straight lines and at an even plane, bedded and
hauched with 100mm class E concrete. (Rounded edge to outside).
- Lay minimum 75mm depth of compacted
M.O.T. type one stone, to a finished level not exceeding plus or
minus 8mm in any direction under a 3 metre straight edge.
- The compacted stone level to finish
below the top line of PCC edging to allow for the exact thickness of
rubber safety tiles and 75mm of concrete oversite.
|
|
Telephone: +44 (0)
01273 833805 Fax/Voicemail [24hr] +44 (0) 1273 831656
Email: info@pjprubber.co.uk
|
|
|
|
